TFP201 EVM Board Configuration and Operation
1-4
Table 1–1. Default PDO Jumper Configuration
Designator
Function
Condition
P19
Jumper SCDT to PDO
Off
P20
Jumper PDO to SW1
On
Table 1–2. Default Power Supply Jumper Configuration
Designator
Function
Condition
P14
Jumper Vcc1 to Vcc2
On
P6
Jumper Vcc1 to PVCC
On
P7
Jumper Vcc1 to AVCC
On
P8
Jumper Vcc1 to OVCC
On
P13
Jumper Vcc1 to DVCC
On
P9
Jumper Vcc2 to IVCC
On
P10
Jumper Vcc2 to PVCC1
On
P11
Jumper Vcc2 to VCC
On
P12
Jumper Vcc2 to AVCC_tx
On
Note:
Power supply jumpers should only be removed and replaced with power turned off.
Power supply supply jumpers can be removed to monitor individual supply currents.
1.3.6
Switch 1 Configuration
Table 1–3 reflects the default configuration of Switch 1 on the TFP201 EVM
board to operate the TFP201 in normal mode. Refer to the data sheet for
specific terminal functions.
Table 1–3. Default TFP201 EVM Switch 1 Configuration
Designator
Function
Condition
1
TFP201 RSVD
Off (high)
2
TFP201 STAG select
Off (high)
3
TFP201 DFO select
On (low)
4
TFP201 PIXS
On (low)
5
TFP201 ST
Off (high)
6
TFP201 OCK_INV select
On (low)
7
TFP201 PD select
Off (high)
8
TFP201 PDO select
Off (high)
Summary of Contents for PanelBus TFP201EVM
