Texas Instruments MultiPkgLDOEVM-823, User Manual, Page: 6 / 22

1 2 3
J3
TP2
C2 R1
J1
VIN
J2
VOUT
J5
GND
J4
GND
R2
C3
TP3
TP1
C1
TP4 TP5
GND
GND
GND GND
GND
OUT
1
OUT
2
FB
3
4
EN
5
NR
6
IN
7
IN
8
9
GND
U1
DRB
C4
Copyright © 2017, Texas Instruments Incorporated
DRB Package
www.ti.com
6 SBVU035 – October 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
Universal Low-Dropout (LDO) Linear Voltage Regulator MultiPkgLDOEVM-
823 Evaluation Module
3.3 EVM Setup
This section describes how to properly connect and setup the MultiPkgLDOEVM-823 for the DRB
package, including the jumpers and connectors on the EVM board.
3.3.1 Soldering Guidelines
To avoid damaging the integrated circuit (IC), use a hot-air system for any solder rework to modify the
EVM for the purpose of repair or other application reasons.
3.3.2 Equipment Connection
Use the following steps when connecting equipment:
1. Set the input power supplies to have a maximum voltage based on the recommended maximum in the
data sheet, and turn the power supplies off.
2. Connect the positive voltage lead from the input power supply to VIN at the J1 connector of the EVM.
3. Connect the ground lead from the input power supply to GND at the J4 connector of the EVM.
4. Connect a load between OUT and GND. The connector used depends on the desired output current.
5. Disable the output by floating J3.
3.4 Operation
Operate the EVM with the following steps:
1. Turn on the power supplies.
2. Enable the output by jumping J3, the EN pin, to VIN.
3. Vary the respective load and input voltage as necessary for test purposes.
3.5 Schematic
Figure 2 is the schematic for the DRB portion of the EVM.
NOTE: No components come populated on the board.
Figure 2. MultiPkgLDOEVM-823 DRB Schematic