Getting
Started
3
device family. Install this version of IAR in a separate folder to be used for F66xx
development.
Note: Downloading the latest IDEs from the TI website will provide you with versions that include
F66xx support. It is not required to install any device specific patches when using these
versions.
4.2
MSP-FET430UIF Installation
1.
Connect the Emulation Interface with the USB cable to a USB port of your PC.
2.
The USB FET should be recognized instantly as the USB device driver should have been
installed already with the IDE installation. If for any reason the Install Wizard starts, respond to
the prompts and point the wizard to the driver files which are located (on a default installation) in
directory:
CCS:
C:\Program Files\Texas Instruments\MSP430_USB_DRIVERS_v3\USB
IAR:
C:\ProgramFiles\IAR Systems\Embedded Workbench x.x\430\drivers\TIUSBFET\WinXP
The MSP430 Hardware Tool User’s Guide (Appendix F) gives detailed instructions how to install
the USB drivers. A link to this document can be found in
www.msp430.com
under the User’s
Guides tab.
3.
Use the 14-conductor (JTAG) cable to connect the evaluation module to a FET programmer (14-
conductor cables are supplied with the FET programmers - parallel PC-FET (MSP-FET430Pxxx)
and USB-FET (MSP-FET430Uxxx)). Ensure that the JTAG cable is plugged in correctly and that
all jumpers (LEDs, and Vcc) are in place.
4.
The evaluation module is now ready to be used for programming and debugging the MSP430.
4.3
MSP-TS430PZ100 USB Target Board
This section gives a brief description of the MSP430F6638 target board; on-board connectors
and jumper settings. Figure1 shows the MSP-TS430PZ100 USB target board.
