4.9.2 Flashing the Board
1. Ensure the drivers have been successfully installed and COM ports enumerated.
2. Configure the SOP to flashing mode.
3. Run the UniFlash tool.
4. Press the reset switch to ensure that the board boots up in the right mode.
5. Enter the Enhanced COM Port in UniFlash interface.
6. Load image to serial flash.
4.9.3 DCA1000
For data capture using the DCA1000, set up the board to MMWAVEICBOOST mode, having the SOP and UART
muxed set correctly. Continue as you would with the IWR6843ISK. For more information, see
4.10 REACH Compliance
In compliance with the Article 33 provision of the EU REACH regulation, this is to notify you that this EVM
includes component(s) containing at least one substance of very high concern (SVHC) above 0.1%. The uses
from Texas Instruments do not exceed 1 ton per year. The SVHC’s are:
Table 4-4. REACH Information
Component
Manufacturer
Component Type
Component Part
Number
SVHC Substance
SVHC CAS (when
available)
Bivar
LED
SM0402GC
1,3,5-tris(oxiranylmethyl)-1,3,5-
triazine-2,4,6(1H,3H,5H)-trione
2451-62-9
xWR6843AOPEVM Rev F
60
mmWaveICBoost and Antenna Module
SWRU546D – OCTOBER 2018 – REVISED NOVEMBER 2020
Copyright © 2020 Texas Instruments Incorporated
