For mounted mode, the UART should be routed to the 60-pin connector. Set up the device as shown in
. When mounted as shown, the SOP mode is overridden by the MMWAVEICBOOST SOP configuration.
Figure 4-15. Switch Configuration for MMWAVEICBOOST Mode
4.9 PC Connection
4.9.1 Installing the Drivers
The SICP2105 drivers must be installed to access the UART port. Download and install the drivers
When installed correctly, the COM port should be enumerated as shown in .
Figure 4-16. SICP2015 COM Ports
The enhanced COM port is the application/user UART and the standard COM port is the data port.
xWR6843AOPEVM Rev F
SWRU546D – OCTOBER 2018 – REVISED NOVEMBER 2020
mmWaveICBoost and Antenna Module
59
Copyright © 2020 Texas Instruments Incorporated
