Texas Instruments mmWaveICBoost, User Manual

Page: 20 / 82

2.7.1 20-Pin LaunchPad and Booster Pack Connectors (J5, J6)
The MMWAVEICBOOST has the standard LaunchPad connectors (J5 and J6) that enable it to be directly
connected to all TI MCU LaunchPad's pinout, as shown in
Figure 2-17 . While connecting the
MMWAVEICBOOST to other LaunchPads, ensure the pin-1 orientation is correct by matching the 3V3 and 5-V
signal marking on the boards.
Figure 2-17 shows two 20-pin connectors.
Table 2-4 and Table 2-5 provide the connector pin information.
Figure 2-17. TI Standard LaunchPad
2.7.2
Table 2-4. J6 Connector Pinout
Pin Number Description Pin Number Description
1 NERROUT 2 GND
3 NERRIN 4 DSS LOGGER
5 MCUCLKOUT 6 SPI_CS
7 NC 8 GPIO1
9 MSS LOGGER (data from xWR device)
(1)
10 nRESET
11 WARMRST 12 SPI_MOSI
13 BSS LOGGER 14 SPI_MISO
15 SOP2 16 HOSTINT
17 SOP1 18 GPIO2
19 SOP0 20 NC
(1) When running the OOB demo, the MSS_Logger pin is used to send data. This is the same pin connected to the XDS110 and displayed
through the emulator as a data COM port.
MMWAVEICBOOST www.ti.com
20 mmWaveICBoost and Antenna Module SWRU546D – OCTOBER 2018 – REVISED NOVEMBER 2020
Submit Document Feedback
Copyright © 2020 Texas Instruments Incorporated