Texas Instruments LP8864, User Manual

Page: 7 / 21

2.6 Additional GUI Functions
In the selection tab on the left-hand side, the user can switch between LED Control, Monitor Faults, Diagnostics
and Register Map tabs. This section introduces GUI functions provided in the Monitor Faults, Diagnostics, and
Register Map tabs.
2.6.1 Monitor Faults Page
From the Monitor Faults page (see Figure 2-6 ), the user has access to LP8864-Q1 fault status bits. Faults can
be cleared by software by clicking the Clear All button. Fault interrupt can be enabled or disabled globally by
toggling the Interrupt All button. Besides that, each fault interrupt and each fault status can be controlled
individually.
Figure 2-6. LP8864EVM Monitor Faults Page
www.ti.com Test Setup
SNVU731 – NOVEMBER 2020
Submit Document Feedback
LP8864 Evaluation Module 7
Copyright © 2020 Texas Instruments Incorporated