Texas Instruments LM63635EVM, User Manual

Page: 3 / 19

LOAD
POWER
SUPPLY
DMM
(+)
(-)
(+)
(-)
(-)
(+)
DMM
(+)
(-)
VIN
VOUT
www.ti.com
Setup
3 SNVU617 – January 2020
Submit Documentation Feedback
Copyright © 2020, Texas Instruments Incorporated
LM63635EVM EVM User’s Guide
1 Setup
This section describes the test points and connectors on the EVM and how to properly connect, set up,
and use the LM63635EVM. Either the test points on the top of the board or the card edge connector can
be used for connections. See
Figure 1 for the top of board connections and Figure 2 for the card edge
connections. The following lists the functions of the connections:
VIN_EMI— Input supply to EVM. Connect to a suitable input supply. See the LM636x5-Q1 3.5-V to 36-V,
1.5-A, and 2.5-A Automotive Step-down Voltage Converter Data Sheet for input supply
requirements.
GND— System ground
VOUT— Output of EVM. Connect to desired load.
VOUTS— Output voltage sense connection (do not use for current; sense only)
VINS— Input voltage sense connection (do not use for current; sense only)
GNDS— Ground sense point for analog measurements (do not use for current; sense only)
Figure 1. EVM Board Connections