Texas Instruments INA230EVM, User Manual

Page: 8 / 27

INA230EVM Hardware
www.ti.com
3.4 Connecting the USB Cable to the SM-USB-DIG Platform
Once power is connected, as shown in Figure 6 , the computer typically responds with a Found New
Hardware, USB Device pop-up dialog. The pop-up window typically changes to Found New Hardware,
USB Human Interface Device. This pop-up indicates that the device is ready to be used. The SM-USB-
DIG Platform uses the human interface device drivers that are part of the Microsoft
®
Windows
®
operating
system.
Figure 6. Connecting the USB Cable to the SM-USB-DIG Platform
In some cases, the Windows Add Hardware Wizard may pop up. If this prompt appears, allow the system
device manager to install the human interface drivers by clicking Yes when requested to install drivers.
Windows then confirms installation of the drivers with the message shown in
Figure 7 .
Figure 7. Confirmation of SM-USB-DIG Platform Driver Installation
8 INA230EVM Evaluation Board and Software Tutorial SBOU124 – March 2012
Submit Documentation Feedback
Copyright © 2012, Texas Instruments Incorporated