2
Board Connection and Configuration
The Vin and GND terminals are the input supply voltage connectors. The isolated
outputs appear at the secondary side terminals: 15VP is the +15V output, 15VN is the -
15V output, 5VP is the +5V output, 5VN is the -5V output, and two IGND are the isolated
ground connectors. To test the board, the electronic load connections should be made
as follows: for positive output, the positive terminal of the load should be tied to 15VP
(5VP), and the return terminal should be tied to IGND; for negative output, the load’s
positive should be tied to IGND, and the return should be tied to 15VN(5VN), and the
negative output loads should be isolated to each other and to the positive output load.
Figure 2 LM5017 Fly-Buck™ Evaluation Board Top Overlay with Connection Instruction
The input voltage range is from 17V to 32V. The max load current is 100mA each for +/-
5V output and 50mA each for +/-15V output. Within the above operation condition, the
overall voltage variation on the output should not exceed 8%.
2.1
+/-5V Dual Output Configuration
To reconfigure the board to +/-5V dual output from the quad output, replace the
transformer 750313995 with 750314225. The max load current becomes 250mA for +/-
5V output.
2.2
+/-15V Dual Output Configuration
To reconfigure the board to +/-15V dual output from the quad output, replace the
transformer 750313995 with 750314226, remove diode D3, D4 and populate the 0Ω
resistor R11, R12. The max load current becomes 75mA for +/-15V output.
Downloaded from
Downloaded from