Instructions to boot out-of-box demonstration
Note: For TI RTOS users, please refer to the RTOS Getting Started Guide at
http://processors.wiki.ti.com/index.php/Processor_SDK_RTOS_Getting_Started_Guide
3
Using the Ethernet cable,
connect the EVM to a
network containing a PC
running a DHCP server.
4
Connect 12 V power cable to
the DC jack (J3). Slide the
power switch SW1 to the
“ON” position marked on the
silkscreen. LED LD9 will
light up.
The host PC will connect
to the EVM, and the
demonstration may now
be run.
6
5
Note the IP address
displayed on LCD screen.
Enter this address into a web
browser connected to the
same network as the EVM.
1
Set DIP switch (SW3) to ‘0111’
(MSB first) as shown to select
MMC/SD boot mode.
2
Prepare a Linux μSD card after
downloading the software from
www.ti.com/mysecuresoftware
and following the instructions
located there.
SPRW309
©2017 Texas Instruments Incorporated
The EVM is delivered with an 66AK2G12 component installed in the socket. Due to shipping, the
component may need to be reseated for proper operation. If the EVM does not boot, see the
EVM User's Guide for instructions on reseating the K2G.
