Texas Instruments DS90UB925QSEVB, User Manual, Page: 7 / 36

www.ti.com
Sept 2012 Literature Number: SNLU113 7
3.3.
ALP Software Setup
3.3.1. System Requirements
Operating System: Windows XP or Vista
USB: 2.0
3.3.2. CD contents
Extract the “ALPF_ xxxxxxxx _ xxx _xxxx.exe” file to a temporary location that can
be deleted later.
Make sure J4 on the DS90UB925 is connected to a PC USB port with the
supplied USB cable and power is applied to the DS90UB925 EVB
The following installation instructions are for the Windows XP Operating System.
3.3.3. Installation of the ALP software
Execute the ALP Setup Wizard program called “ALPF_monthdayyear_major
version_minor version.exe” that was extracted to a temporary location on the local
drive of your PC.
There are 7 steps to the installation once the setup wizard is started:
1. Select the “Next” button.
2. Select “I accept the agreement” and then select the “Next” button.
3. Select the location to install the ALP software and then select the “Next” button.
4. Select the location for the start menu shortcut and then select the “Next”
button.
5. There will then be a screen that allows the creation of a desktop and Quick
Launch icon. After selecting the desired choices select the “Next” button.
6. Select the “Install” button, and the software will then be installed to the selected
location.
7. Uncheck “Launch Analog LaunchPAD” and select the “Finish” button. The ALP
software will start if “Launch Analog LaunchPAD” is checked, but it will not be
useful until the USB driver is installed.
Connect J3 of the DS90UB925Q EVB board to a PC/laptop with the supplied mini
USB cable. Power the DS90UB925Q EVB board with a 3.3 VDC power supply.
The “Found New Hardware Wizard” will open on the PC/laptop. Proceed to the
next section to install the USB driver.