Texas Instruments DLP5534Q1EVM, User Manual

Page: 10 / 12

Quick Start
www.ti.com
10 DLPU096 – November 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
DLP5534Q1EVM Evaluation Module User's Guide
2.2 Software Installation
1. Install the DLPC230-Q1 Control Program ( http://www.ti.com/mysecuresoftware ).
2. Install Total Phase Cheetah USB adapter drivers ( https://www.totalphase.com/products/usb-drivers-
windows ).
2.3 Powering-Up EVM
1. Connect input power cable to a power supply that meets input power specifications defined in Table 6 .
The red wire is the V+ terminal and black wire is the V– terminal.
2. Turn on the supply power. Once powered up, a Controller PCB LED indicator (D4) should illuminate
green.
3. Turn the PROJ_ON switch (SW4) ON. The ON position is towards the closest corner of the board. A
Controller PCB LED indicator (D5) should illuminate green. It is also acceptable to leave the PROJ_ON
switch in the ON position when powering on and off.
2.4 Connecting EVM to the DLPC230-Q1 Control Program
1. Start the DLPC230-Q1 Control Program.
2. On the connection page set the DLPC230-Q1 Host to SPI and select the Cheetah from the drop down
menu (see Figure 5 ). Note that the Cheetah must be connected to computer with USB cable for it to
show up in the drop down box.
Figure 5. Connecting to the DLPC230-Q1 Using the DLPC230-Q1 Automotive Control Program