Quick Start
12
DLPU097 – November 2019
Copyright © 2019, Texas Instruments Incorporated
DLP5534PROJQ1EVM Evaluation Module User's Guide
3. Select "Connection Settings" to confirm the SPI configuration shown in
matches the Controller
PCB switch settings described in
. Specifically, SPI mode and CRC/Checksum may vary based
on switch settings. Press "OK" once configuration is complete.
Figure 7. DLPC230-Q1 Automotive Control Program Communication Settings
4. Click the Connect button. The green circle next to the Connect button should then light up to indicate
that connection was successful to the Cheetah Adapter.
2.5
Steps to Reprogram the Onboard Flash Memory
The DLP5534PROJQ1 EVM comes with onboard serial Flash that is pre-programed with software and
basic configuration. The software and configuration can be updated by reprogramming the serial Flash
with the DLPC230-Q1 Automotive Control Program. Steps to re-program the serial Flash are listed below.
1. Using the DLPC230-Q1 Automotive Control Program, which is connected to the EVM, navigate to the
"Flash Program" tab.
2. Using the folder icon, select an Image File (.bin) and open it.
3. Click "Program and Verify Flash Memory."
Note that if the device is in Display mode, it will automatically be switched to Standby during programming.
