Texas Instruments DLP5530PGUQ1EVM, User Manual

Page: 12 / 16

Quick Start
www.ti.com
12 DLPU090 – November 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
DLP5530Q1EVM Evaluation Module User's Guide
2 Quick Start
Use the following instructions to setup the DLP5530Q1EVM and PC.
2.1 Kit Assembly Instructions
A diagram of all connections is shown in Figure 5 .
1. Connect the controller to driver control interface flex to the controller PCB (J8) and the illumination
driver PCB (J4).
2. Connect the host SPI cable to the controller PCB (J2) and the Cheetah adapter. Connect the Cheetah
adapter’s USB cable to PC.
3. Connect the controller power cable to the controller PCB (J11) and the illumination driver PCB (J3).
4. Connect the blue illumination output cable to the illumination driver PCB (J5) to the blue illuminator in
the optics engine.
5. Connect the green illumination output cable to the illumination driver PCB (J6) to the green illuminator
in the optics.
6. Connect the red illumination output cable to the illumination driver PCB (J7) to the red illuminator in the
optics engine.
7. Connect the photodiode cable to the controller PCB (J5) to a photodiode located in the illumination
path of the optics engine.
8. Connect the Micro HDMI cable to the controller PCB (J3). Connect the Micro HDMI cable to PC HDMI
port.
9. Connect the power input cable to the illumination driver PCB (J1).
(1) Reference letters refer to cables listed in Table 7 .
Figure 5. EVM Cable Connections