Pattern Modes
34
DLPU028C – October 2014 – Revised November 2016
Copyright © 2014–2016, Texas Instruments Incorporated
Operating the DLP LightCrafter 6500 and 9000
4.
Each pattern in the display can now be selected individually or a multiple selection can be done. To
select multiples patterns in a series, use
Shift+Click
. To select multiple patterns that are not in a
series, use
Ctrl+Click
. An alternate method for selecting all images is to use the
Select All Patterns
button on the
Menu
bar.
5. Select the first pattern and choose a bit depth of 1. Set exposure to 100000 µs and set dark time to
50000 µs. The dark time is the time from the end of one pattern to the start of the next pattern. Select
Red
for the color.
6. Select the second pattern and choose a bit depth of 1. Set exposure to 150000 µs and set dark time to
75000 µs, and select
Green
as the color.
7. Select the third pattern and choose a bit depth of 1. Set exposure to 200000 µs and set dark time to
100000 µs, and select
Blue
as the color.
shows the pattern sequence. The
Zoom
bar can
be used to zoom in and out. This is useful when many patterns are loaded into the panel.
Figure 3-8. Three Pattern Sequence
8. Select the
Repeat
radio-button to continuously repeat the pattern sequence, or, if only one time is
desired, then select the
Play Once
radio-button.
9. Click the
Update LUT
button to upload the pattern sequence definition, including the three pattern
images, to the DLPC900. If there are any errors in the pattern sequence, the GUI will display an error
message.
10. Once the upload is complete, click the
Start
button. The display should repeatedly display the Red,
Green, and Blue dots.
11. To pause the pattern sequence, click the
Pause
button. To continue from where the pattern sequence
paused, click the
Start
button.
12. To stop the pattern sequence, click the
Stop
button. To restart the pattern sequence click the
Start
button. The pattern sequence will start from the beginning whenever the pattern sequence is stopped
using the
Stop
button.