Texas Instruments DLP LightCrafter 6500, User Manual, Page: 13 / 60

J18
J17
J2
J1
J7
J20
J24
J23
J16
J10
J12
J8
J11
SW1
J9
J6
J5
J3
J4
J25
J25
J21
J19
J13
J14
J15
D6
D5
D9
D8
www.ti.com
DLP LightCrafter 6500 Connections
13 DLPU028C – October 2014 – Revised November 2016
Submit Documentation Feedback
Copyright © 2014–2016, Texas Instruments Incorporated
DLP LightCrafter 6500 and 9000 Module Overview
1.5 DLP LightCrafter 6500 Connections
Figure 1-5 depicts the switches and connectors with their respective locations. Note that neither cables
nor the power supply is included with the module.
Figure 1-5. DLP LightCrafter 6500 Connectors (Top View)
• SW1 – Reset switch. When pressed, resets the controller.
• J1 – HDMI Connector. Default primary video input after power is applied to the EVM.
• J2 – DisplayPort Connector. Secondary video input.
• J3 – HDMI EDID jumper. When jumper is installed, the EDID prom can be updated.
• J4 – DisplayPort EDID jumper. When jumper is installed, the EDID prom can be updated.
• J5 – OCLKA connector. Configurable output clock A.
– Bits per second: 115200
– Data bits: 8
– Parity: None
– Flow Control: None
– Pin 1 = 3.3 V
– Pin 2 = TX out
– Pin 6 = Ground
• J7 – USB connector. USB interface to PC or host for communications with the DLPC900.
• J8 – JTAG ICE. Used for debugging code. Requires the ARM RVI ICE debugger.
• J9 – Controller RESET jumper. When jumper is installed, the controller is held in RESET.