www.ti.com
3.1
Basic Operating Set-Up
3.2
Software Control and Operation
3.2.1 User Interface Panel
Basic Operating Set-Up
Follow these steps to set up the DEM-DAI3793A/3794A EVM for operation.
Step 1.
When using the kit for the first time, install the
TUSB3410 VCP
(Virtual COM Port) driver to
the host PC. To install the driver, refer to the Virtual COM Port Driver Installation
Instructions.pdf located in the DEM-DAI3793 folder of the software CD or available
through
the TI web site
.
Step 2.
Connect the audio signal sources and/or receiver, using one of these connections:
•
S/PDIF cable (optical or coaxial)
•
Analog input/output (RCA)
Step 3.
Connect microphone, speakers, headphone, an audio amplifier, or measurement equipment,
if necessary.
Step 4.
Confirm that jumpers CN103–CN107 are shorted.
Step 5.
Connect the USB cable between the host PC and the motherboard (CN201).
Step 6.
Apply +6V to +10V to the motherboard (CN101, CN102 for power supply).
Step 7.
Execute EVM3793A.exe.
When the installation is complete, the EVM software is ready to use.
This section of the user's guide reviews the operation and configuration of the EVM controller software.
After finishing the installation process (as explained in
Section 3.1
), the user interface panel shown in
Figure 3-1
appears.
Figure 3-1. User Interface Window
22
Set-Up Guide
SBAU127 – July 2007
Submit Documentation Feedback
Summary of Contents for DEM-DAI3793A
Page 1: ...DEM DAI3793A 3794A EVM User s Guide July 2007 AIP Consumer Audio TI Japan SBAU127...
Page 2: ...2 SBAU127 July 2007 Submit Documentation Feedback...
Page 16: ...Description 16 SBAU127 July 2007 Submit Documentation Feedback...
Page 72: ...Schematic PCB Layout and Bill of Materials 72 SBAU127 July 2007 Submit Documentation Feedback...
