Texas Instruments DAC53701EVM, User Manual, Page: 8 / 38

2.2.2 Connecting the Hardware
After the TI Launchpad firmware is upgraded as described in Section 2.1.3 , and power and jumper
configurations set up as per Section 2.2.1 , the BOOSTXL-DAC-PORT and DAC53701EVM can be connected as
shown in Figure 2-6 . Connect the USB cable from the TI Launchpad OTG USB Port (U7) to the PC.
Figure 2-6. Hardware Setup Guidelines
2.2.3 Electrostatic Discharge Warning
Many of the components on the DAC53701EVM are susceptible to damage by electrostatic discharge (ESD).
Observe proper ESD handling precautions when unpacking and handling the EVM, including the use of a
grounded wrist strap at an approved ESD workstation.
System Setup www.ti.com
8 DAC53701EVM SLAU841 – OCTOBER 2020
Submit Document Feedback
Copyright © 2020 Texas Instruments Incorporated