3.2.2.3.3 Functions Tab
The next tab on the
Quick-Start
page is
Functions
for function generation, as shown in
provides the ramp programming done through code-step and slew-rate settings.
Figure 3-9. DAC Quick Start Page: Function Generation
The most basic setting for this functionality is the function selection: triangular wave, saw-tooth wave, reverse
saw-tooth wave, and square wave.
The margin-low and margin-high settings define the lower and the upper bounds of the waveform, respectively.
The toggle button starts or stops the defined function generation.
Any change to the function settings can only be done when the function is off.
The register settings can be programmed or retrieved using the EEPROM
PROGRAM
or
RELOAD
buttons,
respectively.
Detailed Description
SLAU841 – OCTOBER 2020
DAC53701EVM
19
Copyright © 2020 Texas Instruments Incorporated