SWRU048
Page 25 of 30
Table 6: ISP header connector
Bootloader
The CC2400DB is shipped with a bootloader. This loader communicates with AVR Studio.
After reset the bootloader must have a way to determine to start program mode or to run the
application software residing in the application code section of the flash. To start the
bootloader the Joystick center push on CC2400DB is used to enter program mode. This
button his held low after reset while starting the AVR Prog from the Tools menu in AVR
Studio until the bootloader program window is loaded. See figure 15 and 16.
Step-by-Step procedure:
1. Connect the CC2400DB serial port to your PC COM port
2. Connect power to CC2400DB
3. Start AVR Studio
4. Select Tools from the menu (See figure 15)
5. Reset CC2400DB and hold the Joystick Center push button down after reset and
start AVR Prog, bootloader will start (See figure 16)
6. Browse to find your application program *.hex file
7. Click on the Flash Program to program the flash
Important note:
If you should program the EEPROM please contact Chipcon Technical Support
8. Disconnect serial port
9. Reset
CC2400DB
10. Start your application program
Figure 15: Starting AVR Prog in AVR Studio
Summary of Contents for Chipcon CC2400DBK
