![background image](http://html1.mh-extra.com/html/texas-instruments/bq28400evm-001/bq28400evm-001_user-manual_1095245012.webp)
Hardware Connection
www.ti.com
To start charge or discharge test, connect the PRES pin to the Pack– pin to set PRES state. To test sleep
mode, disconnect the PRES pin.
Figure 9. bq28400 Circuit Module Connection to Cells and System Load/Charger
7.2
PC Interface Connection
To configure the hardware to interface to the PC, follow these steps:
1. Connect the bq28400-based smart battery to the EV2x00 using wire leads, as shown in
Table 4. Circuit Module to EV2x00 Connections
bq28400-Based Battery
EV2x00
SMBD
SMBD
SMBC
SMBC
VSS
GND
2. Connect the PC USB cable to the EV2x00 and the PC USB port.
The bq28400 is now set up for operation.
12
bq28400EVM-001 SBS 1.1 Compliant Tablet PC and Netbook 2-Series Cell
SLUU494 – February 2011
Li-Ion Battery Gas Gauge and Protection
© 2011, Texas Instruments Incorporated