Texas Instruments bq25910EVM-854, User Manual

Page: 3 / 21

www.ti.com
Introduction
3 SLVUB31A – September 2017 – Revised March 2018
Submit Documentation Feedback
Copyright © 2017–2018, Texas Instruments Incorporated
bq25910EVM-854 Evaluation Module
Table 2. bq25910EVM Ports
Port Description
J1 bq25898D PMID port
J2 bq25898D SYS output
J3 bq25898D and bq25910 VBUS input
J4 Battery connector for both bq25898D and bq25910
J5 I
2
C Molex connector
J6 bq25910 PMID port
Table 3. bq25910EVM Jumpers
Jumper Description
Default
Configuration
JP1 Pullup selection jumper. Choose between SYS or BAT. Installed to SYS
JP2 bq25898D battery sense line Installed
JP3 bq25910 INT pin jumper Installed
JP4 bq25898D CE pin (charge enabled) Installed
JP5 bq25898D REGN to TS network connection Installed
JP6 TS network connection to potentiometer Installed
JP7
TS to GND connection. Can also be used to attach an external 103AT
thermistor.
Not Installed
JP8 bq25898D OTG to GND pin connection Installed
JP9 bq25898D ILIM to GND pin connection Not Installed
JP10 bq25910 IND_SNS pin connection Installed
JP11 bq25910 BATP sense line connection Installed
JP12 bq25910 BATN sense line connection Installed
Table 4. bq25910EVM Test Points
Test Point Description
VBUS1_s Sense line for the bq25898D VBUS for efficiency measurement
PMID1 Connection to the bq25898D PMID plane
VBUS2_s Sense line for the bq25910 VBUS for efficiency measurement
PMID2 Connection to the bq25910 PMID plane
BAT_s bq25898D battery sense line
BATP bq25910 positive battery sense line
BATN bq25910 negative battery sense line
GND_s bq25910 sense line to GND plane near IC for efficiency measurement
SW1 bq25898D switch node
SW2 bq25910 switch node
VOUT_910_s bq25910 converter output for efficiency measurement
CFLY+/CFLY– Differential test points for the bq25910 CFLY capacitor
CDRV+/CDRV– Differential test points for the bq25910 CDRV capacitor
INT2 bq25910 Interrupt pin
CAUX bq25910 CAUX capacitor
REGN bq25910 REGN output