Texas Instruments BQ25886, User Manual

Page: 3 / 25

www.ti.com
Introduction
3 SLUUC11 – February 2019
Submit Documentation Feedback
Copyright © 2019, Texas Instruments Incorporated
BQ25886 QFN Standalone boost-mode battery charger evaluation module
Advance Information
Table 3. EVM Jumper Connections and Shunt Installation
Jack Description BQ25886 Setting
JP1 STAT, PG, CE pins 3.3-V LDO pullup source of either SYS (pin 1 to 2) or BAT (pin 2 to 3) Shunt pins 2 and 3
JP2 ILIM pin connection to resistor to GND Installed
JP3 Connects D+ pin to pin 3 of J5 mini-USB port Installed
JP4 DNI NA
JP5 TS resistor divider pullup source (REGN) connection Installed
JP6 Connects D– pin to pin 2 of J5 mini-USB port Installed
JP7 Connects an onboard 10 k Ω from TS pin to GND Installed
JP8 Connects OTG pin to GND Open
JP9 Connects CE pin to GND Installed
JP10 Pulls up STAT through diode and resistor to pullup source Installed
JP11 Pulls up PG through diode and resistor to pullup source Shunt pins 2 and 1
JP12 Pull up GND pin to GND Shunt pins 2 and 3
JP13 NC pin Open
JP14 DNI NA
JP15 Pull up CE pin through 10-k
Ω
resistor Open
JP16 Connects VSET to GND through 18-k Ω resistor sets VREG to 8.2V Open
JP17 Connects VSET to GND through 39.2-k Ω resistor sets VREG to 8.8V Open
JP18 Connects VSET to GND through 75-k Ω resistor sets VREG to 8.7V Open
JP19 Connects VSET to GND through 150-k Ω resistor sets VREG to 8.4V Installed
Table 4 lists the recommended operating conditions for this EVM.
Table 4. Recommended Operating Conditions
Symbol Description MIN TYP MAX Unit
Supply voltage, V
VBUS
Input voltage from AC adapter 4.3
Battery voltage, V
BAT
in charge
mode
Voltage applied at V
BAT
terminal 0 or
floating
8.4 9.2 V
I
BAT
Fast charging current 0 — 2.2 A
Discharging current through internal MOSFET 6 — — A
Supply current, I
IN
Maximum input current from AC adapter input 0 — 3.3 A