Texas Instruments bq25600, User Manual

Page: 3 / 24

www.ti.com
Introduction
3 SLUUBK9 – September 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
bq25600, bq25600D PWR771 Evaluation Module
Table 3 lists the EVM jumper connections.
Table 3. EVM Jumper Connections and Shunt Installation
Jack Description bq25600 Setting bq25600D Setting
JP1 D+ and PSEL pin selection Short PSEL to low Not installed
JP2 CE pin setting: pull low to enable the charge Installed Installed
JP3 SCL and OTG pin setting Not installed Not installed
JP4 STAT, PG, CE, INT, OTG pins internal pullup source (VSYS
or BAT) Short to VSYS Short to VSYS
JP5 TS pin to GND Not installed Not installed
JP6 TS resistor divider pullup source (REGN) connection Installed Installed
JP7 Internal 10 k to GND to TS pin Installed Installed
JP8 BATSNS selection Short to BAT Short to BAT
JP9 QON and VSET pin setting Not installed Not installed
JP10 STAT pin setting Installed Installed
JP12 SDA and PG pin setting Installed Not installed
JP13 D+ and PSEL to J3 Not installed Installed
JP14 D- and PG to J3 Not installed Installed
JP15 D- and PG pin setting Installed Not installed
JP100 Add 1-µF (C100) VBUS capacitor Not installed Not installed
JP101 Add 10-µF (C101) PMID capacitor Not installed Not installed
JP103 Add 10-µF (C103) SYS capacitor Not installed Not installed
JP104 Add 4.7-µF (C104) BAT capacitor Not installed Not installed
S1 QON control Default off Default off
S2 Switch to short indicator LEDs Default off Default off
Table 4 lists the recommended operating conditions for this EVM.
Table 4. Recommended Operating Conditions
Symbol Description MIN TYP MAX UNIT
Supply voltage, V
VBUS
Input voltage from AC adapter 3.9 5 14 V
Battery voltage, V
BAT
Voltage applied at V
BAT
terminal 0 4.208 4.624 V
I
BAT
Fast charging current 0 2.5 A
I
BATOP
Discharging current through
internal MOSFET 0 6 A
Supply current, I
IN
Maximum input current from AC
adapter input 0 3.25 A