Texas Instruments BQ2515 EVM Series, User Manual, Page: 3 / 25

VIN
VIO/VDD
Connection
Charge
Enable/
Disable
Low Power Mode /MR Push Button
EV2400 Connector
VBAT
www.ti.com
Introduction
3 SLUUBV0A – July 2018 – Revised August 2019
Submit Documentation Feedback
Copyright © 2018–2019, Texas Instruments Incorporated
BQ2515xEVM Evaluation Module
Table 2. Jumper Connections (continued)
J11 VIO connector to VDD or 3p3V Connect VDD to VIO
J12 /LP connector to GPIO or VIO Connect /LP to VIO
J13 /CE connector ro GPIO or VIO Connect /CE to VIO
J14 Display connector for other modules NA
J15 PMID to VINLS connector Connected
J16 On board LED pullup to VDD or PMID Connected to PMID
J17 I2C Pullup Connected
Table 3 lists the recommended operating conditions for this EVM.
Figure 1. BQ2515xEVM Connections
Table 3. Recommended Operating Conditions
Symbol Description MIN TYP MAX Unit
Supply voltage, V
VBUS
Input voltage from AC adapter 5 20 V
Battery voltage, V
BAT
in charge mode Voltage applied at V
BAT
terminal 4.2 V
I
BAT
Fast charging current 0.5 A
Discharging current through internal MOSFET 1 A
Supply current, I
IN
Maximum input current from AC adapter input 0.6 A