BOOSTXL-ADS7142-Q1 EVM Initial Setup
12
SBAU321A – November 2018 – Revised August 2019
Copyright © 2018–2019, Texas Instruments Incorporated
BOOSTXL-ADS7142-Q1 BoosterPack™ Plug-In Module
3.3.4
General Instructions
This section describes the steps involved in selecting functional modes of operation or channel-specific
configurations and capturing the data in the selected functional mode:
1.
Enable All Channels
and
Enable Alert
on the top right corner of GUI page.
2. Enter channel-specific configurations such as high and low thresholds, hysteresis, and Alert
functionality.
3. Select
Conversion Mode
by clicking on either
Autonomous Mode
or
Manual Mode
.
4. Select the
Operating Mode
from drop-down menu and click
SET
to write register specific to that
particular mode.
5. Press
Start Sequence
to capture conversion data from ADS7142-Q1.
NOTE:
The
Start Sequence
button will remain disabled until the selected
Functional Mode
is
SET
as
step 4 indicates.
Figure 11. ADS7142-Q1 General Instructions Page
