Brushed Motor Demo Application
•
In the
Debug Menu
, right click on the
TI MSP430 USB1_0
connection and select
Connect Target
(see
Figure 9. Connect Target Selection
•
After the device connects, go to
Run -> Load -> Load Program
(see
). Browse to the
BOOST-DRV8848 Hardware and Software Files
folder that was downloaded from the tool folder.
Go into the
Application
subdirectory and then go into the GUI subdirectory. Select the
appProgram.out
file (Application\BOOST-DRV8848_GUIvX.X\appProgram.out).
Figure 10. Load Program Selection
•
After a short delay, the appProgram.out file is loaded onto the MSP430G2553 (see
). An
error message may display saying that the source was not found. Receiving this message is OK,
as long as the binary was loaded.
Figure 11. Load Program Complete
•
Close CCS
9
SLVUAE1 – December 2014
BOOST-DRV8848
Copyright © 2014, Texas Instruments Incorporated
