![background image](http://html1.mh-extra.com/html/texas-instruments/awrl6432boost/awrl6432boost_user-manual_1094148013.webp)
6.4 Connectors
Higher current support: When using the EVM with the external power adaptor, the 5-V supply is provided by
the external power adaptor. For most of the use-cases this external power supply option is not used, power is
derived from the USB interface.
Note
After the 5-V power supply is provided to the EVM, TI recommends pressing the NRST switch one
time to ensure a reliable boot-up state.
Note
All digital IO pins of the device (except NRESET) are non-failsafe; hence, care needs to be taken that
they are not driven externally without the VIO supply being present to the device.
6.5 USB Connector
The USB connector provides a 5-V supply input to power the device; additionally the PC interface is brought out
on this connector:
• UART for flashing the onboard serial flash, downloading FW through Radar Studio, and getting application
data sent through the UART
Figure 6-8. USB Connector (J5)
6.6 DCA1000 HD Connector
The 60-pin HD connector shown in
provides the high-speed data and controls signals (SPI, UART,
I2C, NRST, NERROR, and SOPs) to the DCA1000.
XWRL6432BOOST Antenna
SWRU596 – DECEMBER 2022
IWRL6432BOOST/AWRL6432BOOST EVM: FR4-Based Low Power 60 GHz
mm-Wave Sensor EVM User Guide
13
Copyright © 2022 Texas Instruments Incorporated