Texas Instruments AWR1843AOP EVM, User Manual, Page: 23 / 29

For mounted mode, the UART should be routed to the 60-pin connector. Set up the device as shown in Figure
2-23 . When mounted as shown, the SOP mode is overridden by the MMWAVEICBOOST SOP configuration.
Note
The EVM shown in Figure 2-22 is mounted in the elevation orientation. Refer to Section 2.4 for more
details.
Figure 2-23. Switch Configuration for MMWAVEICBOOST Mode (Functional)
2.9.3 DCA1000 Mode
This mode enables raw data capture using the DCA1000 EVM.
Figure 2-24. AWR1843AOPEVM Mounted on the DCA1000
Note
The EVM shown in Figure 2-24 is mounted in the elevation orientation. Refer to Section 2.4 for more
details.
For mounted mode, the UART should be routed to the 60-pin connector. The SOP settings are controlled by the
SOP switches on the AWR1843AOPEVM. Set up the device as shown in
Figure 2-25 .
www.ti.com Hardware
SPRUIX8 – MARCH 2021
Submit Document Feedback
AWR1843AoP EVM User’s Guide 23
Copyright © 2021 Texas Instruments Incorporated