Introduction
4
SPRUIE6 – April 2017
Copyright © 2017, Texas Instruments Incorporated
AMIC110 Industrial Communications Engine (AMIC110 ICE)
Figure 2. AMIC110 ICE JTAG Connection
3. Connect the pin header connector of the TTL-232R-3V3 serial cable to J3 on the AMIC110 ICE (see
). Ensure that pin 1 of the serial cable (black wire, marked with a triangle) is connected to pin 1
of J3 (indicated by a dot on the silk screen).
See
TTL to USB Serial Converter Range of Cables Datasheet
for information about the TTL-232R-3V3
cable.
4. Connect the USB connector of the serial cable to a PC host port.
5. Connect a CAT5 Ethernet cable from a PC running TwinCAT software to PHY1 (J6 – ECAT IN) of the
ICE board. If users have multiple ICE boards in a chain, connect another CAT5 Ethernet cable from
PHY2 (J7 – ECAT OUT) to PHY1 of the next ICE board. PHY2 of the last ICE board in the chain is left
open.
Figure 3. AMIC110 ICE Serial Port Connection
