Texas Instruments ADS8371EVM, User Manual, Page: 20 / 33

As a Reference Board
5-2
5.1 As a Reference Board
As a reference design, the ADS8371EVM contains the essential circuitry to
showcase the analog-to-digital converter. This essential circuitry includes the
input amplifier, reference circuit, and buffers. The EVM analog input circuit is
optimized for a 100-kHz sine wave; therefore, users may need to adjust the
resistor and capacitor values of the A/D input RC circuit. In AC type
applications where signal distortion is a concern, polypropylene capacitors
should be used in the signal path.
5.2 As a Prototype Board
As a prototype board, the buffer circuit consists of a standard 8-pin SOIC
footprint and resistor pads for inverting and noninverting configurations. The
ADS8371EVM can be used to evaluate both dual-supply and single-supply
amplifiers. The EVM comes installed with a dual-supply amplifier as it allows
the user to take advantage of the full input voltage range of the converter. For
applications that require single-supply operation (and a smaller input voltage
range), the THS4031 can be replaced with a single-supply amplifier like the
OPA300. Pad jumper SJP2 should be shorted between pads 1 and 2, as it
shorts the minus supply pin of the amplifier to ground. Positive supply voltage
can be applied via test point TP5 or connector J3, pin 1.
5.3 As a Software Test Platform
As a software test platform, connectors P1, P2, and P3 plug into the parallel
interface connectors of the 5−6K interface card. The 5−6K interface card sits
on the TMS320C5000

and TMS320C6000

DSP platform starter kit (DSK).
The ADS8371EVM is then mapped into the processor memory space. This
card also provides an area for signal conditioning. This area can be used to
install application circuit(s) for digitization by the ADS8371 analog-to-digital
converter. See the 5−6K interface card user’s guide (SLAU104) for more
information.
For the software engineer, the ADS8371EVM provides a simple platform for
interfacing to the converter. The EVM provides standard 0.1-inch headers and
sockets to wire into prototype boards. The user need only provide 3 address
lines (A2, A1, and A0) and address-valid line (DC_CS) to connector P2. To
choose the address combinations that generate RD and CONVST, set
jumpers as shown in Table 3−2. Recall that the chip select (CS) signal is not
memory-mapped or tied to P2; therefore, it must be controlled via a general
purpose pin or shorted to ground at J2 pin 1. If address decoding is not
required, the EVM provides direct access to converter data bus via P3 and to
control via J2.