Texas Instruments ADS7854EVM-PDK, User Manual, Page: 11 / 35

www.ti.com
ADSxx54EVM-PDK Initial Setup
5.2.2 Verify Jumpers are in the Factory-Default Position and Connect the Hardware
The ADSxx54EVM-PDK includes both the ADSxx54EVM and the SDCC controller board; however, the
devices are shipped unconnected. Follow these steps to verify that ADSxx54EVM-PDK kit is configured
and connected properly.
Step 1. Verify the microSD card is installed on the back of the SDCC board, as shown in Figure 5 .
Step 2. Verify the ADSxx54EVM jumpers are configured as shown in Figure 4 .
Step 3. Connect the ADSxx54EVM board to the SDCC controller board as Figure 6 illustrates.
Figure 6. Connecting ADSxx54EVM Board to SDCC Controller Board
Step 4. Connect the SDCC controller board to the PC through the micro USB cable.
Step 5. Verify that the LED D5 Power Good indicator is illuminated. Wait approximately ten seconds
and verify that diode D2 blinks, indicating that USB communication with the host PC is
functioning properly.
Figure 7 shows the location of the LED indicators in the SDCC controller
board.
Figure 7. LED Indicators on the SDCC Board
11 SBAU209 – April 2014 ADS8354EVM-PDK and ADS7854EVM-PDK
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated