Texas Instruments ADS7853EVM-PDK, User Manual, Page: 14 / 41

ADSxx53EVM-PDK Initial Setup
www.ti.com
5.2.2 Verify Jumpers are in the Factory-Default Position and Connect the Hardware
The ADSxx53EVM-PDK includes both the ADSxx53EVM and the simple capture card controller board;
however, the devices are shipped unconnected. Follow these steps to verify that ADSxx53EVM-PDK kit is
configured and connected properly.
Step 1. Verify the microSD card is installed on the back of the simple capture card board; see
Figure 7 .
Step 2. Verify the ADSxx53EVM jumpers are configured; see Figure 6 .
Step 3. Connect the ADSxx53EVM board to the simple capture card controller board as Figure 9
shows.
Figure 9. Connecting the ADSxx53EVM Board to the Simple Capture Card Controller Board
Step 4. Connect the simple capture card controller board to the PC through the micro USB cable.
Step 5. Verify that LED D5 Power Good indicator is illuminated. Wait approximately ten seconds and
verify that diode D2 blinks, indicating that USB communication with the host PC is functioning
properly.
Figure 10 shows the location of the LED indicators in the simple capture card
controller board.
Figure 10. LED Indicators on a Simple Capture Card Board
14 ADS8353EVM-PDK and ADS7853EVM-PDK SBAU210A – June 2014 – Revised August 2014
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated