Texas Instruments ADS7040, User Manual

Page: 6 / 28

ADS7040EVM-PDK Initial Setup
www.ti.com
Complete the following steps to install the software:
Step 1. Ensure that the microSD memory cards on both the Simple Capture Card and ADS7040 are
installed.
Step 2. Verify jumpers are in the factory-default positions and connect the hardware.
Step 3. Locate, copy and install the ADS7040EVM software to the PC.
Step 4. Complete the device driver installation.
Each of these steps is described in the following subsections.
5.2.1 Install the microSD Memory Cards on the Simple Capture Card Controller Board
As mentioned in the previous section, the ADS7040EVM-PDK includes two microSD memory cards. One
is installed on the microSD socket (P6) at the back of the Simple Capture Card as shown in
Figure 3 . The
second microSD memory card is installed on the mircoSD socket (J2) at the back of the ADS7040EVM as
shown in
Figure 4 .
Figure 3. Bottom View of Simple Capture Card with microSD Memory Card Installed
Figure 4. Bottom View of ADS7040EVM Board with microSD Memory Card Installed
6 ADS7040EVM-PDK SBAU240 – November 2014
Submit Documentation Feedback
Copyright © 2014, Texas Instruments Incorporated