Software Installation
9
SBAU200C – June 2012 – Revised April 2020
Copyright © 2012–2020, Texas Instruments Incorporated
Performance Demonstration Kit for the ADS131E08
2.3.2
Installing the Second USB Driver
Launch the ADS131E08EVM-PDK software from the program menu. The software loads and begins
downloading firmware to the processor on the MMB0. After the firmware is loaded and running, the
Found
New Hardware Wizard
starts again, as shown in
Figure 10. Second New Hardware Wizard Screen
Click
Next
and the screen in
appears.
Figure 11. Installing the USBStyx Driver
Click
Next
to complete the installation. If the computer is unable to find the USBStyx driver, point to the
installation directory of
C:\Program Files\ADS131E08EVM\USB Drivers
.
At this time, you may receive an error message because the ADS131E08EVM-PDK software has timed
out. If so, click
OK
, close the GUI program, power cycle the ADS131E08EVM, and restart the newly
installed ADS131E08 evaluation program. This process may need to be repeated if you plug the
ADS131E08EVM-PDK into a different USB port on your computer.
Summary of Contents for ADS131E08EVM-PDK
Page 31: ...Top Assembly Top Layer...
Page 32: ...Internal Layer 1 Internal Layer 2...
Page 33: ...Bottom Layer Bottom Assembly...