Texas Instruments ADS126 EVM-PDK Series, User Manual, Page: 19 / 38

GPIO
Test DAC
1 Input MUX
7 Data \ MODE
2 Reference
8 Calibration
3 Digital Filter
9 Register Map
4 IDAC / Sensor Bias
5
10 Extras / About
6
www.ti.com
ADS126xEVM Software
3. Configure the ADS126x. The ADS126xEVM plugin is divided into ten tabs, as shown in Figure 15 .
Clicking on a tab changes the displayed controls. The controls on each tab are described in
Section 3.4 .
Figure 15. ADS1262EVM Plugin Tabs
4. Select a test plugin from the Test file menu, as shown in Figure 16 . This step may precede steps 1 to
3, but is required before acquiring data in the next step.
Figure 16. Loading a Test Plugin in ADCPro
5. Acquire data by clicking the Acquire or Continuous button (previously shown in Figure 14 ). These
buttons are only operational when both the EVM and test plugins are loaded. Clicking Acquire captures
a single block of data. Clicking Continuous captures blocks of data repeatedly. The block size is
configured in the test plugin.
6. Use the test plugin functions as described in the ADCPro User's Guide, SBAU128 , to analyze the ADC
conversion data.
19 SBAU206 – April 2015 ADS126xEVM-PDK
Submit Documentation Feedback
Copyright © 2015, Texas Instruments Incorporated