Texas Instruments ADS1178EVM, User Manual, Page: 26 / 52

ADS1278EVM-PDK Kit Operation
www.ti.com
Figure 23. Install New Driver Wizard Screen 5
5. Once Windows finishes installing the software driver, the plug-in downloads the firmware to the MMB0.
The status area will display Connected to EVM when the device is connected and ready to use. If the
firmware does not load properly, you can try resetting the MMB0 by pressing reset and then reloading
the plug-in.
6. You can verify the proper installation of the USBStyx driver using the Device Manager. Note that the
first driver item, NI-VISA USB Devices, will disappear and a new item, LibUSB-Win32 Devices will
appear, as
Figure 24 shows.
Figure 24. USBSytx Driver Verification Using Device Manager
The driver installation wizard sequence should not appear again, unless you connect the board to a
different USB port.
ADS1178EVM, ADS1278EVM, ADS1178EVM-PDK, and ADS1278EVM-PDK 26 SBAU129C – November 2007 – Revised July 2008
Submit Documentation Feedback