-
+
Ch. A Analog Input
ADC
Ch. B Analog Input
USB Register
Configuration
Connector
CLK Input
F
MC
C
o
n
n
e
c
to
r
(B
a
c
k
-s
id
e
)
LMK
Input Power
Connectors
Primary (+4V)
SYSREF Input
EXTREF Input
(Optional LMK04828
reference)
JP1
Equipment
2
Equipment
This section describes how to setup the EVM on the bench with the proper equipment to evaluate the full
performance of the ADC device.
2.1
Evaluation Board Feature Identification Summary
Figure 1. EVM Feature Locations
2.2
Required Equipment
The following equipment and documents are included in the EVM evaluation kit:
•
Evaluation board (EVM)
•
Mini-USB cable
The following equipment is not included in the EVM evaluation kit, but is required for evaluation of this
product.
•
TSW14J56EVM data capture board plus +5-V power supply and mini-USB cable
•
High Speed Data Converter Pro software
•
PC computer running Windows XP, 7, or 8
•
Two low-noise signal generators. TI recommends the following generators:
–
RF generator, > +17 dBm, < –40 dBc harmonics, < 500 fs jitter 20 kHz to 20 MHz, 10 MHz to 2
GHz frequency range
–
HP HP8644B
–
Rohde & Schwarz™ SMA100A
•
Bandpass filter for clock input (370MHz or desired frequency). The following filters are recommended:
–
Bandpass filter,
≥
60 dB harmonic attenuation,
≤
5% bandwidth, > +18 dBm power, < 5 dB insertion
loss
–
Trilithic™ 5VH-series tunable BPF
–
K&L Microwave™ BT-series tunable BPF
–
TTE KC6 or KC7-series fixed BPF
•
Bandpass filter for analog input signal. Recommended filters similar to the clock path filter.
•
6-dB resistive attenuator, SMA, 50
Ω
•
Signal-path and clock-path cables, SMA or BNC (or both SMA and BNC)
•
+4 V, 2-A power supply and cable
6
ADC16DX370EVM User's Guide
SLAU529A – February 2014 – Revised December 2014
Copyright © 2014, Texas Instruments Incorporated
