Texas Instruments ADC12DL3200, User Manual

Page: 15 / 24

15 SLAU776 – May 2018
Submit Documentation Feedback
Copyright © 2018, Texas Instruments Incorporated
Device Configuration
Chapter 3
SLAU776 – May 2018
Device Configuration
The ADC device is programmable through the serial programming interface (SPI) bus accessible through
the FTDI USB-to-SPI converter located on the EVM. A GUI is provided to write instructions on the bus and
program the registers of the ADC device.
For more information about the registers in the ADC device, see the ADC12DL3200 data sheet .
3.1 Tab Organization
Control of the ADC device features are available in the EVM , Control , Input/Sampling/LVDS , and Trim
configuration tabs.
3.2 Low-Level Control
The Low Level View tab, illustrated in Figure 3-1 , allows configuration of the devices at the bit-field level.
At any time, the controls in Table 3-1 can be used to configure or read from the device.
Figure 3-1. Configuration GUI: Low-Level View Tab