Texas Instruments ADC08060, User Manual

Page: 5 / 16

PC Computer
Running HSDC Pro
ADC08060
EVM
TSW1400
EVM
Power
Switch
Mini-USB to
USB-A Cable
xxx
xxx
xxx
xxx
x xx
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x x
x
x
x
x
x
x
Analog Input
Low Noise
Signal Generator
10-MHz
Bandpass Filter
Low Noise
Power Supply
+5VDC @3A
10.1 MHz
Vin = -1 dBFS
Copyright © 2017, Texas Instruments Incorporated
Copyright © 2017, Texas Instruments Incorporated
www.ti.com
Quick-Start Guide
5 SLAU715 – February 2017
Submit Documentation Feedback
Copyright © 2017, Texas Instruments Incorporated
ADC08060 Evaluation Module
2.2 Hardware Setup Procedure
A typical test setup using the ADC08060EVM and TSW1400EVM is shown in Figure 2 . This is the test
setup used for the quick-start procedure. The rest of this section describes the hardware setup steps.
Figure 2. Quick-Start Test Setup
2.2.1 TSW1400EVM Setup
First, set up the TSW1400EVM using the following steps:
1. Connect the ADC08060EVM to the TSW1400EVM connecting pin 1 of the CMOS_INTERFACE (J1) to
pin 1 of ADC08060EVM output data (J1).
2. Connect the power cable to connector J12 (5 V IN) to the TSW1400EVM.
3. Connect the mini-USB cable to the USB connector (J5).
4. Turn on the power supply. Flip the power switch (SW7) to the ON position. The board should draw
around 0.5 A after power up. This will increase to around 1.7 A when loaded with firmware.