Texas Instruments 5-6K, User Manual

Page: 3 / 15

2.2 Signal Conditioning Power Connector
3 Serial EVM Sites
3.1 Serial Digital I/O Connections
3.2 Chip Select, Frame Sync and Interrupt Options
www.ti.com
Serial EVM Sites
The Interface Board provides a common power bus to both signal conditioning sites. The power connector
used on the Interface Board is a 6-pin male header. Four power connectors JP1, JP2, JP3, and JP4 are
provided—each with the same pinout. This allows an analog-to-digital (ADC) converter to use the same
signal conditioning board as a digital-to-analog (DAC) converter, simply by rotating the signal conditioning
board 180 degrees.
Table 3 shows the power connector voltages supplied to the signal conditioning module.
Table 3. Signal Conditioning Power Connections—JP1, JP2, JP3, and JP4
Signal Pin Number Signal
+VA 1 2 -VA
+5VA 3 4 -5VA
AGND 5 6 AGND
The serial interface consists of two digital I/O connectors (J15 and J16), two power connectors (JP5 and
JP6), and two analog I/O connectors (J10 and J12). The analog I/O connectors are configured as pass
through connections from/to the signal conditioning sites. See
Section 2.1 for more information.
The serial site digital I/O connectors are 20-pin headers that provide access to the serial interface signals
defined in the TMS320 Cross-Platform Daughtercard Specification (
SPRA711 ). These signals are based
on the multichannel buffered serial port (McBSP) interface found on most Texas Instruments DSPs.
Table 4 shows the standard serial connector pinout.
Table 4. Digital I/O Connections—J15 and J16
Signal
(1)
Signal
(1)
Pin Number
Site 1 (J15) Site 2 (J16) Site 1 (J15) Site 2 (J16)
DC_CNTLa DC_CNTLb 1 2 TP Access TP Access
DC_CLKXa DC_CLKXb 3 4 DGND DGND
DC_CLKRa DC_CLKRb 5 6 TP Access TP Access
DC_FSXa DC_FSXb 7 8 TP Access TP Access
DC_FSRa DC_FSRb 9 10 DGND DGND
DC_DXa DC_DXb 11 12 TP Access TP Access
DC_DRa DC_DRb 13 14 TP Access TP Access
EVM_INTa EVM_INTb 15 16 TP Access TP Access
DC_TOUTa DC_TOUTb 17 18 DGND DCND
TP Access TP Access 19 20 TP Access TP Access
(1)
Revision B boards include 470-
Ω
pulldown resistors at all points listed as TP Access via 6-position slide switches SW1 and
SW2.
DC_CNTLa and DC_CNTLb are routed directly to pin 1 of the Digital I/O connectors (J15 and J16
respectively) on Revision A Interface Boards. Revision B interface boards include jumpers W12 and W13
which apply the DC_CNTLx signal (default) or digital ground (shunt pins 2-3) to pin 1 of the digital I/O
connectors.
SLAU104C – May 2004 – Revised March 2009 List of Tables 3
Submit Documentation Feedback