Texas Equipment CS 6000S, Manual

Page: 12 / 20

7
Attach the handle (D1)
over the handle rod (U)
from left side.
Insert the bolt (D) through
the dispenser lever (Y)
further through the handle
(D1) and the handle rod
(U) Fasten nut (L) a little
bit for now.
Insert spacer (O) onto the
upper hole of the handle
rod (U). Attach the bolt
(D) onto handle (D1),
secure with nut (L). Now
tighten the other bolts to
secure the handle.
Attach the hopper (Z)
above the frame (B1) and
the deflector (A1) from
below the frame (B1) and
align. Secure with bolt
(E), washer (J) and nut
(L).
Important: Adjust bracket
on the gear(S) and
ensure that the
deflector (A1) flaps are
pulled down before
installation.
Attach the R pin (N) from
the inside of the
hopper (Z) onto the
impeller shaft.
Attach rod (V) to the
dispenser lever(Y) at one
end and the connector (T)
at the other end, secure
with nut (L).
Attach the rod from the
connector (T) onto the
bracket underneath the
hopper (Z) insert the
washer (K) and nut (L)
to secure.
8
9
12
D1
U
Y
D
L
O
Z
E
B1
L
A1
J
S
N
Z
V
V
V
T
Y
L
K