9
Change of brush
Figur 5
6a) Insert brush (A) onto axel B
6b) Insert pin (13) into the hole in the shaft and tighten
the nut (11) with tool (12).
Always disconnect power before changing brush!
Remember!
You can acquire more brushes on www.TEXAS.dk
Operation
Use the electric weed cleaner to remove weeds
between flagstones and pavers.
Activate brush by pressing on switch (figure 2) with
fingers, while pushing Safety lock-off (figure 6) on the
side of the handle. Release both to stop.
Do not press the brush down onto the surface. This will
increase the pressure on the brush and decrease its
working life. Extension cords longer than 50 feet must
not be coiled, but must be rolled out, lying loosely on
the ground.
Storage
Clean the machine after use. Make sure no debris gets
in through the cooling slots of the motor housing. Store
the cleaner in a frost free area, out of reach of children.
Specifications
TYPE
Electric Weed Cleaner
Voltage (V)
230 – 240 ~50 Hz
Output (Watt)
140
RPM
1200
Max brush
diameter
100 mm
Protection class
II
LpA
68 dB(A)
LwA
88 dB(A)
Weight (kg)
1,9
Vibration
1,6 m/s2
Warranty terms and conditions
The warranty period is 2 years for private end users in
EU countries.
Products sold for commercial use, only have a warranty
period of 1 year.
The warranty covers material and/or fabrication faults.
Normal wear and replacement of wearing parts are
NOT covered by the warranty.
Wearing parts, which are NOT covered for more than
12 months:
All kinds of brushes
Wheels
Cables
Fuses
Switches
Printed circuit boards (PCB)
Covers
The warranty does NOT cover damages/faults caused
by:
Lack of service and maintenance
Structural changes
Exposure to unusual external conditions
Damages to the bodywork, protection guards,
panels etc.
If the machine has been improperly used or
overloaded
Use of unoriginal spare parts.
Other conditions where Texas cannot be held
responsible.
* We reserve the right to change the conditions and
accept no liability for any misprints
