TEXA 10TD088A0, Manual

Page: 55 / 185

At the end of each processing the tool beeps, the LED flashes and the
resonance frequency of the belt is shown.
6. Repeat the measurement 3 times and calculate the average of the read
values.
The values to be used for the calculation of the average must
have a difference not higher than 3 Hz.
7. Use the calculated value to derive with the special tables the tension of
the belt.
At the end of the 10 seconds the tool comes back to the status " Press to
start ... ".
7.3.1 Work Zone lighting
The LED near the microphone enables to light the belt stretch and the work
zone.
Proceed as follows:
Press and release the power button.
The led lights on.
The LED will turn off automatically after about 10 s.
55
en