BATTERY INSTALLATION OF REMOTE CONTROL
9
13
Remote control operation range
●When there is an obstacle between the remote and the transmitter, the unit may not operate.
●When direct sunlight, an incandescent lamp, fluorescent lamp or any other strong light
shines on the REMOTE SENSOR of the unit, the operation of the remote may be unstable.
Battery installation:
1.Slide and lift the battery door.
polarity markings.
3.Close up the battery door.
Follow these precautions when using a battery in this device:
2.Use only the size and type of battery specified.
3.Be sure to follow the correct polarity when installing the battery as indicated in the
battery compartment. A reversed battery may cause damage to the device.
4.Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old
batteries with new ones.
5.If the batteries in the device are completely drained or the device will not be used for a
long period of time, remove the batteries to prevent damage or injury from possible
battery leakage.
6.Do not try to recharge batteries not included to be recharged; they can overheat and
rupture. (Follow battery manufacture’s instructions.)
7.The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
9.Clean the battery contacts, and also those the device, prior to battery installation.
Battery precaution:
8.Remove batteries promptly if consumed.
1.Warning-Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type.
2.Install two “AAA” size batteries into the battery
compartment as indicated by the
