Helpline No. UK/ North Ireland 0871 37 61 020 Rep. Ireland 1-800-992 508
Web Support www.medion.co.uk
Model Number: 82663
22
Incorporating delays
It can be useful to incorporate a time delay before a command step in order to take
the warm-up phase of the TV set into consideration, for example. The standard delay
between the infrared signals is equal to half a second.
While entering the steps (see above) press the
PAUSE
key at
the point where the time delay should be incorporated.The
DELAY TIME?
query appears.
Press a number key corresponding to the seconds by which
you would like to delay (e.g.
3
for a 3-second delay). The
maximum delay is 9 seconds.
Executing macros
To execute a macro, briefly press the
MACRO
key once in
normal mode. The following message appears:
MACRO KEY?
.
Then press the number key where the macro was saved within
20 seconds (
1
,
2
or
3
).
While the macro is running,
MACRO 1
(or
2
or
3
) appears along
with the transmission symbol.
If no macro is saved under the selected numberkey, the
message
MACRO 1 VOID
appears.
Deleting macros
Perform steps 1 to 3 as described in section “Programming
macros“ on page 21. The
MACRO SET
display appears.
Use the arrows
to select the
MACRO CLEAR
mode.
Press
OK
" The following message appears:
MACRO KEY?
.
Press the number key where the macro is stored for the macro
that you would like to delete.
The
CONFIRM CLEAR
prompt appears.
Confirm once again with
OK
.
PLEASE WAIT
appears again in the
display, followed by the confirmation message
SUCCESS
.
The remote control returns to normal operation.