TEUPEN LEO 30T, Translation Of The Original Operating Instructions

Page: 219 / 224

23 TROUBLESHOOTING
ENGLISH
B
When engine suddenly stops
A
When the engine has suddenly stopped, decompress
the engine by the decomp and turn the engine lightly
by pulling on the fan belt. If the engine turns easily
without abnormalities, the cause of the trouble is
usually lack of fuel or bad nozzle.
B
When color of exhaust is especially bad
B
When engine must be stopped immediately
B
When engine overheats
Cause Countermeasures
Lack of fuel
*Check the fuel tank and refill the fuel, if
necessary.
*Also check the fuel system for air or
leaks.
Bad nozzle
*If necessary, replace with a new
nozzle.
Moving parts are
overheated due to
shortage of
lubrication oil or
improper
lubrication.
*Check amount of engine oil with oil
level gauge.
*Check lubricating oil system.
*At every 2 times of oil change, oil filter
cartridge should be replaced.
*Check to see if the engine bearing
clearances is within factory specs.
Cause Countermeasures
Fuel governing
device bad
*Contact dealer for repairs.
Fuel is of extremely
poor quality. *Select good quality fuel.
Use No. 2-D diesel fuel only.
Nozzle is bad. *If necessary, replace with new nozzle.
Combustion is
incomplete.
*Cause is poor atomization, improper
injection timing, etc. Because of trouble
in injection system or in poor valve
adjustment, or compression leakage,
poor compression, etc.
Check for the cause.
Cause Countermeasures
Engine revolution
suddenly
decreases or
increases.
*Check the adjustments, injection timing
and the fuel system.
Unusual sound is
heard suddenly.
*Check all moving parts carefully.
Color of exhaust
suddenly turns
dark.
*Check the fuel injection system,
especially the fuel injection nozzle.
Bearing parts are
overheated.
*Check the lubricating system.
Oil lamp lights up
during operation.
*Check the lubricating system.
*Check, if the engine bearing
clearances are within factory specs.
*Check the function of the relieve valve
in the lubricating system.
*Check pressure switch.
*Check filter base gasket.
Cause Countermeasures
Engine oil
insufficient *Check oil level. Replenish oil as
required.
Fan belt broken or
elongated
*Change belt or adjust belt tension.
Coolant insufficient *Replenish coolant.
Excessive
concentration of
antifreeze
*Add water only or change to coolant
with the specified mixing ratio.
Radiator net or
radiator fin clogged
with dust
*Clean net or fin carefully.
Inside of radiator or
coolant flow route
corroded
*Clean or replace radiator and parts.
Fan or radiator or
radiator cap
defective
*Replace defective parts.
Thermostat
defective *Check thermostat and replace if
necessary.
Temperature gauge
or sensor defective *Check temperature with thermometer
and replace if necessary.
Overload running *Reduce load.
Head gasket
defective or water
leakage
*Replace parts.
Incorrect injection
timing
*Adjust to proper timing.
Unsuitable fuel
used
*Use the specified fuel.
Courtesy of CraneMarket.com