6
• Ultima 20 Mk 2
Connecting
Connection variations
A connector terminal with four
terminal clips is located on the
back side of the speakers. Here
you can connect the speaker
cables directly or with pin plugs.
We only describe the direct con-
nection in these instructions.
The terminals are each marked in
red (+) and black (-).
Connecting the cables
Danger
Danger of injury/damage!
Arrange the cables so that they do not pose a
trip hazard.
1. Turn off your amplifier.
2. Lay the speaker cables from your amplifier to each
speaker. These cables should be high-quality double-
wire speaker cable with marked strands. The diameter
should amount to at least 1.5 mm
2
.
Make sure the polarity is correct!
Connect the same-colour terminals of your
speakers and amplifier with each other. Oth-
erwise the sound quality will suffer. The individual single
wires of the speaker cables are marked with different
colours or shapes to facilitate the process.
3. Split the single wire down to approx. 30 mm on both
ends and strip approx. 10 mm of insulation off of each
cord. Twist the stripped single wire ends together so
that no wire protrudes.
4. Turn the connector terminals counterclockwise until
loose. Run the stripped single wire ends into the holes
that are now visible. Turn the terminal clockwise until
closed.
The cable has now been clamped in place.
5. Connect the speaker cables to your amplifier. The
operating instructions of the appliance should contain
notes on this.
