• Theater 80
Connecting
Danger
Danger of injury/damage!
Arrange the cables so that they do not pose a
trip hazard.
Satellite speakers
Pull the mains plug of your AV receiver out of the
socket.
Lay the speaker cord from your AV receiver to each of
the satellites. This should be a bifilar cord with marked
wires. It should have a diameter of at least 1.5 mm
2
.
Tip: Mark the cords on the receiver side. This is helpful
whenever you take down and set up the receiver.
A connector comprising two terminals is located on the
back of each satellite speaker.
There, you can connect the speak-
er cords with the banana plugs
or directly. These instructions only
describe direct connection.
The terminals are each marked in
red (+) and black (-).
Ensure that the polar-
ity is correct!
Connect the like coloured terminals with one
another. Otherwise the sound quality will suffer. The
speaker connectors of your AV receiver should have
similar markings. The speaker cord wires are marked
with different colours or have different forms.
Split the helix on both ends up to approximately 30 mm
and remove approximately 10 mm of the insulation on
each piece. Twist the helix so that no wires are protrud-
ing.
Loosen the connector terminal by turning it counter-
clockwise. Now run the stripped cord end into the hole
that has become visible. Close the terminal by turning
it clockwise. The cord has now been clamped in place.
Connect all cords to the satellite speakers by following
these steps.
Connect the speaker cords to your AV receiver. The
operating instructions for your device should provide
information on this.
The crossover frequency between satellite speakers
and subwoofer has to be set to 120 Hz at the AV
receiver.
Subwoofer
You now need an RCA connector. This way, you can con-
nect the RCA jack
“In” on the back of the subwoofer
with the RCA jack for the subwoofer of the receiver. You
will find more information on this in the operating instruc-
tions of the receiver.
•
•
•
•
•
•
•
•
•
Connecting to a power supply
Ensure that the main switch
5
“Power” has been deac-
tivated (setting “0 OFF”).
Connect the mains connector jack
with a mains
socket using the mains cord
d
.
Also insert the mains plug of your AV receiver back in
the socket.
•
•
•
2
5
6
91240_00_T_00 20090527.indd 8
27.05.2009 9:27:13 Uhr